Menu
Installing a reach-in freezer correctly is very important so that it works well and lasts a long time. You don’t want problems like uneven cooling, leaks, or using too much energy because of mistakes in the installation.
By knowing about and avoiding these common mistakes when installing a fridge, you can make sure it works well for a long time. If you want to save money and enjoy trouble-free operations, hire a reach-in freezers installation service in Dallas .
1.Not Big Enough or Too Small
If you don’t get the right size of the freezer system for your needs, it will fail. It’s that easy. There is a good chance that a system that is too small will not work well or at all and will likely break down quickly. A too big system will, among other things, use much more electricity than you planned. An over-sized system will have to turn on and off more often than you would like to keep your chilled area at a steady temperature.
2.Not Considering Leveling Out
Making sure the reach-in freezer is level is one of the most forgotten parts of installing it. If you don’t level the refrigerator, it might not cool right or even break. To fix this, use a leveling tool to make sure the freezer is level, and then adjust the legs as needed. This small change can have a big effect on how well it works.
To level it, do these things:
3.Not Enough Space For Ventilation
Running a freezer makes heat, which needs to escape through the proper vents. Putting the equipment too close to the wall or other machines can block the flow of air, which can cause it to get too hot and work less well.
Around a freezer, leave at least one inch of space at the back and two to three inches of space on all sides. This lets the airflow and circulation work right. To make sure there is enough airflow, follow the manufacturer’s instructions for space.
Also Read: 6 reasons you should hire experts for reach-in freezer installation
4.Misalignment Of The Doors
Cool air can leak out and make the fridge work too hard if the fridge door isn’t lined up right. Check that the doors are lined up correctly and, if necessary, fix the hinges or gaskets to make sure a good seal and good insulation.
5.Not Enough Refrigerant Charge
For a cooling system to keep working right, it needs the right amount of refrigerant. That you don’t check the refrigerant in your system as part of regular repair for your important systems is a mistake that will cost you a lot of money. Not only can the wrong amount of refrigerant increase your energy bills, but an inefficient system is more likely to break down and need fixes more often. This one is simple; just do a few checks to avoid extra costs.
6.Ignoring Electrical Needs
If you plug the freezer into a power source that isn’t strong enough, it could shut down often or cause an electrical safety risk. Check the unit’s voltage and amperage to make sure the plug and circuit can handle the load. For commercial freezers, it’s best to use a circuit that is just for them.
To make sure your reach-in freezer lasts as long as possible and works well, you must avoid making common installation mistakes. By hiring reach-in freezers installation service Dallas, they will make sure that the equipment works well, your energy bills are low, and your food stays fresh.
Looking for the best company to install your reach-in freezer? Choose Greentex Coolers! Contact us if you need to set up commercial refrigeration.
Most manufacturers recommend at least 2-4 inches of clearance around the freezer’s sides, back, and top to ensure proper airflow and prevent overheating.
It depends on the power requirements of the freezer. Commercial reach-in freezers require a dedicated circuit with the correct voltage and amperage. Always check the manufacturer’s guidelines before plugging it in.
After installation, allow the freezer to run for at least 4-6 hours or until it reaches the recommended operating temperature before loading food.
Leave A Comment